Assembly Guide

ManualsBrandsLynxmotion ManualsRobot Construction Kit PartsAluminum Hexapod 3-R Body Kit (Brushed)

H3-R Body Assembly Instructions Rev. 5.

Safety first! Wear eye protection and never touch a powered robot!

The purpose of this guide is to construct the chassis, attach the legs, and install the

electronics. As long as the servo horns have not been removed from the servos, you do

not have to center them during the assembly process.

Note: This document shows the BH3-R in the images. The procedure is the same for all

the kits.

Step 1.

Use the 4-40 x 1/4" hex socket screws to attach the spacers to the underside of the top

panel.

12 x

Summary of content (6 pages)

PAGE 1
H3-R Body Assembly Instructions Rev. 5. Safety first! Wear eye protection and never touch a powered robot! The purpose of this guide is to construct the chassis, attach the legs, and install the electronics. As long as the servo horns have not been removed from the servos, you do not have to center them during the assembly process. Note: This document shows the BH3-R in the images. The procedure is the same for all the kits. Step 1.
PAGE 2
Step 2. Use the 4-40 x 1/4" hex socket screws to attach the bottom of the robot to the spacers. Note, the bottom panel is symmetrical, meaning there is no front or back. 12 x Step 3. The SSC-32 should be configured for 115.2 kbaud and DB9 communication, with the VS2=VS1 jumper installed. Remove the VL=VS jumper. Consult the SSC-32 manual if needed. Attach the wiring harness to VS1. Connect 8" of 24awg wire (not included) AND the 9v battery clip to VL; this will provide power for the electronics.
PAGE 3
end of the wire. Using four 4-40 x 3/8" hex socket head screws, attach the 1.0" hex spacers to the board as shown. 4x Schematic. Double check your connections against the schematic below.
PAGE 4
Step 4. Slip the SSC-32 in through the hole in the top of the robot and use four 4-40 x 3/8" hex socket screws to attach the board as shown. Make sure the DB9 port on the board is at the front of the robot, opposite the power switch hole! This will ensure you can easily plug in the servo cables. Install the power switch in the power switch hole at the rear of the robot.
PAGE 5
Step 5. Install all the legs. Refer to Figure 5 for clarification. 12 x Step 6. Plug the servos into the SSC-32 as illustrated in Figure 6. Simply plug in the servo associated with the function to the corresponding pin. If oriented correctly, the I/O port (group of four pins) will be closest to its corresponding leg. Refer to Schematic 3-1 for detailed information.
PAGE 6
Step 7. This completes the mechanical assembly. You can now move on to the Complete H3/H3R Tutorial.