Electronic Guide

LynxmotionUAV
ElectronicConfiguration
STEP 2: Connections
A) Power Harness
EachESCneedstobepowereddirectlyfromthebattery.Assuch,apowerdistributionboard
(PDB)orpowerwiringharnessisusedtosplitthebatterytofourseparateconnectors.Plugin
eachoftheESCstooneconnectorontheharness.Wesuggestrunningthisharnessbetween
thecentermiddleandlowermiddleplatesbeforeyoumaketheconnections.Notethatthefifth
connectorconnectstothebattery.Youcanremovethetopplateifit’seasierforyou,butbesure
toreattachitwhendone.
QuadcopterpowerwiringharnessconnectstoeachESCaswellasthebattery.
YoumightbewonderingwhythereisnoOn/Offswitchincludedwiththekits?Thesafestwayto
knowthattheUAVmotorswon’tspinupaccidentallyistoremovepowercompletelyby
unpluggingthemainbattery.Aswitchcanbeaccidentallytouchedwhensomeoneisaround,
causingthepropellerstoturnathighRPM.