Electronic Guide

LynxmotionUAV
ElectronicConfiguration
InaVTail,thetworearpropellersstillneedtobepushingairDOWNWARDS.Thereforedespite
themotorbeingupsidedown,thepropellershouldhavethetopfacingup.
NoticethetopofthepropellerisstillfacingupwardsintheVtail
H) Receiver Placement
Thereceiverdoesnotweighmuch,butit’simportantthatitbesecuredtotheframe.Centering
thereceiveralongtheframeisalwaysideal,thoughmostofthetimethisiswheretheflight
controllerneedstobeplaced.Wesuggestthereceiverbesecuredtoatopplateorjustinfront
oftheflightcontrollerusingtiewrapsand/ortape.
I) Battery
Atthispoint,everythingexceptforthebatteryshouldbeinstalledandconnected.Thebattery
itselfshouldideallybelocatedunderneaththeUAVtowardsthecenteroftheUAVsothatthe
UAVdoesnothaveatendencytopitchforward/backwardorrollleftorright.Youcanconnect
thebatteryusingtheprovidedvelcrostrap(s).
J) Cleaning up Wires
Sometipstocleaningupyourwiring:
● EachESCshouldideallybelocatedonthecopter’sarmbeneaththepropellerwashto
helpitcooloff.Youcanusetape,tiewrapsorothermeanstosecureeachofthemin
place.
● Anylongwiresshouldbetiedupandtapedtotheframesotheydon’tgettangledinthe
blades.
● ReceiverAntenna: