User Guide

Step A5: The Hitec 485HB servo is shipped with its white plastic horn centered. If the horn is

rotated by accident, ensure it lines up like the image below. It should rotate 90 degrees CCW

and 90 degrees CW. Without moving the horn itself unscrew the black screw holding the horn in

place and KEEP IT for step A9). Pull the white plastic horn straight off of the servo.

Step A6: Place the servo in the base as shown and screw it in using four #4 x ⅜” Phillips head

tapping screws included with the base rotate kit. Note that the holes are not tapped - the screws

need to be turned and pressed to force thread the plastic.

RobotShop Inc. 305-18005 Lapointe, Mirabel, Quebec, Canada, J7J0G2