User Guide

Assembly

Note that there is also an online assembly guide from Lynxmotion for the AL5D (which uses

photos), as well as a YouTube video, however this manual is an updated version, so we

suggest using ONLY this guide for the assembly steps.

A. Base

Step A1: Insert the 1/16” x ⅜” stainless steel pins into the 6mm black plastic beads as shown

(5x)

● 5x steel pins

● 5x plastic beads

Step A2: Install the bearings into the base as shown. They will fit snugly. Note, the notch in the

bottom edge of the base (shown below) indicates the back.

● 5x plastic bead assemblies

● 1x base rotate (bottom)

RobotShop Inc. 305-18005 Lapointe, Mirabel, Quebec, Canada, J7J0G2