Assembly Instructions (RTF)

3 SEDONA by LYNX™ Ready to Finish Island Assembly Instrucons
SEDONA by LYNX™ READY TO FINISH ISLAND ASSEMBLY INSTRUCTIONS
Congratulaons on your purchase of the SEDONA by LYNX™ Ready to Finish Island. The
prefabricated unnished island can be assembled in no me at all. No tools are necessary
for island assembly, but a Philips head screwdriver and a reciprocang saw are required
for adjustments. The island comes ready for you to add your own personal touch in
components, nishes and countertops. Mulple openings are provided for a variety of
SEDONA by LYNX™ accessories.
Before you begin the island installaon you will need to plan ahead. Some things to consider:
Power Supply and Venng:
The Ready to Finish Island is not pre drilled or cut for power and venng access. You will have to cut through the
rear panel to create access points where required. When venng, cut vents in your grill island that are at least
4” x 14” every 4-6’ of island. The vents should be near the top for natural gas: closer to the boom if using LP gas.
Cover vents with louvered stainless steel covers if desired.
Island Orientaon:
While you have the opon of a le hand or right hand orientaon, it is important for proper operaon that wind
does not blow directly into the rear of the grill. Consider posioning the island to take advantage of natural wind
breaks.
Leveling the Island:
If the base is not level, adjust the legs before any of the panels are installed. If the island is not leveled correctly
the panels could be misaligned and cannot be adjusted once assembly is complete. Once fully assembled, the
island is dicult to move.
Assembling the Island:
You will need assistance holding panels in place while assembling. The panels are large and heavy, therefore we
recommend two people to avoid any injuries during assembly.
If you have any quesons or comments please
contact Lynx Customer Care:
Lynx Professional Grills
7300 Flores Street.
Downey CA 90242
Lynx Customer Care 888.289.5969