manual

10
|
SEDONA SIDE BURNER ACCESSORY CARE & USE/INSTALLATION
SAFETY PRACTICES AND PRECAUTIONS
Ensure that burner ties and all packing materials are re-
moved before lighting any new accessory.
AT EACH NEW SEASON
At the start of each new grilling season you should remove
the cooking grates and check the burners, venturis, orifices
and valves for obstructions.
Spiders and insects often nest in these areas of the acces-
sory and can disrupt air flow, causing damage to the acces-
sory and personal injury.
Also, check all hoses and fittings for damage, abrasion,
wear and tear and repair, if necessary, before turning the
gas on.
The 4/11 gas pressure regulator, Lynx part number 30781
supplied with the unit must be used for natural gas, or
LP supplied from a bulk storage system. The regulator is
factory preset, and convertible for either natural or LP gas.
(See INDEX: “Converting for Fuel Type” for further details.)
If connection to a Type 1, 20 lb LP cylinder is required, a LP
gas pressure regulator and hose assembly is required and
it must be the type specified by Lynx. (See INDEX: “Con-
tacting Lynx”.) When a LP gas pressure regulator and hose
assembly is used, the 4/11 regulator must be removed to
prevent over-regulation.
Leak check all connections with a soap and water solution
before operating the burners. Turn all knobs to OFF and
SLOWLY turn on the gas supply valve. (See INDEX: “Leak
Testing” for further details.)
Do not use any grill or side burner if you smell gas.
LIGHTING INSTRUCTIONS
1. Remove burner cover completely. Do not attempt to
light any burner with the cover in place
2. Ensure all knobs are in the OFF position. Test the igni-
tion system by pressing in the burner control knob
and looking and listening for the clicking sound of
the igniter. If no spark is visible and no clicking sound
is heard, proceed with match-lighting or refer to the
trouble shooting section.
3. Turn on the main gas supply and purge if needed.
4. Push in and turn the burner control knob to the LITE
position and hold for 5 seconds.
5. If burner does not light, turn knob to OFF, wait 5 min-
utes to allow gas to dissipate and repeat step 4 above
PURGING THE GAS LINES
You should purge the gas line of air before attempting to
light the grill accessory.
1. Make sure all grill controls are in the “OFF” position.
2. Slowly turn on the main gas supply.
3. Push in the control knob for the burner furthest from
the fuel source. Using the burner furthest from the fuel
source will completely purge the lines. It will take sev-
eral seconds for the burner to light.
4. Hold the knob ON for about 20 seconds to allow the
air in the system to purge and the burner to light
5. Wait at least 5 minutes after shutting off the control
before attempting to light the burners.
Lighting instructions for ALL Accessories
1. DO NOT store or use gasoline or other flam-
mable vapors and liquids in the vicinity of this
or any other appliance.
2. An LP cylinder not connected for use shall
not be stored in the vicinity of this or any
other appliance.
WarnIng