Care and Use Manual / Installation

10
CARE AND USE/INSTALLATION
USING YOUR ELECTRONIC CONTROL
Set
Colder Warmer
ON/OFF
Press and Hold Press and Hold
Alarm
F
Figure 12
close-up of
control
• Temperature Sensor Fault: If the control-
ler detects that the temperature sensor is
not properly functioning, a temperature
sensor alarm will sound in one (1) second intervals. "E1"
will ash on the display panel and the Alarm LED located at
the top left of the display below the word "Alarm" will be il-
luminated. Please call Lynx Grills Customer Service or your
dealer if this error code is displayed.
• High and Low Temperature Alarm: If the
storage compartment temperature deviates
excessively from the set-point temperature, the
alarm will sound in (1) second intervals. The
display panel will ash either "Hi" or "Lo" de-
pending upon the condition and the Alarm LED
light at the top left of the display below the word
"Alarm" will be illuminated. The alarm will remain active
until the condition is corrected.
Your electronic control will monitor wine cellar function and
alert you with a series of audible and visual alarms.
• Door Ajar Alarm: If the door has been left
open for over ve (5) minutes, the alarm
will sound in one (1) second intervals. The
display panel will ash "do" and the Alarm LED located at
the top left of the display below the word "Alarm" will be il-
luminated. This will stop as soon as the door is closed.
Figure 13
Starting Your Wine cellar
Turning Your Wine cellar ON or OFF
Setting the temperature
Wine cellar Operation
Alarms
Plug the wine cellar power cord into a wall outlet. Your wine
cellar will begin cooling after power is applied.
If your wine cellar does not start, check that the wine cellar
is turned on and the set temperature is cold enough.
If the wine cellar is on, the wine cellar temperature will be
shown on the display. To turn the wine cellar off, press and
hold the "ON/OFF" button for three (3) seconds. "OFF" will
appear on the display.
If the wine cellar is not on, "OFF" will be shown on the
display. To turn the wine cellar on, press and hold the "ON/
OFF" button for three (3) seconds. The wine cellar tem-
perature will be shown on the display.
To set the wine cellar temperature, press and hold the
"SET" button. When the "SET" button is pressed, the
display will show the set temperature. While holding the
"SET" button, press the "WARMER" or "COLDER" buttons
to adjust set temperature.
The available temperature range of the wine cellar is 40°F
(4.5°C) to 65°F (18.4°C).
It may take up to 24 hours for your wine cellar to reach
desired temperature. This will depend on amount of content
loaded and number of door opening and closings.
For best results allow wine cellar to "pull down" to desired
set temperature before loading. Once contents are loaded,
allow at least 48 hours for temperature to stabilize before
making any adjustments to the set temperature.
Display
light
switch