Manual


LynxModelNo.LHFS Page25 P/N33348Rev.A7/2010
Maintenance and Trouble Shooting
Trouble Shooting
1. No gas supply at burner:
• Ensure manual shut off valve is in proper position
• Ensure there is pressure and flow at inlet to gas valve.
• Ensure LP-Gas Cylinder has fuel in it.
2. No spark:
• Ensure battery in ignition module is operating.
• Ensure spark electrode assembly is grounded and there are no cracks in ceramic insulator.
• Ensure the gap (spark gap) between Pilot and Spark Ignitor electrode is 1/8” – 3/16” (3mm –
4.5mm) as per picture below.
3. Flame lights but will not stay lit:
• Be sure to hold knob in for one minute or longer to allow sensor to get hot.
• Ensure there is no overpowering wind.
• Ensure sense electrode is not corroded, is not grounded or has a cracked insulator. Electrode
position is radially across face of burner.
Replacement Parts
• Use only manufacturer recommended replacement parts.
• For a complete list of replacement parts contact your dealer.
1/8”(3mm)Gap