User Manual

LCS30 COCKTAIL STATION CARE & USE/INSTALLATION

1. Install the faucet or the stainless steel plug (included) into the top faucet opening.

2. Carefully lower the sink into the cut out on the counter top. Push the sink back unl there are no gaps in the

back and the bullnose contacts the front face of the cabinet. The sink will be supported by its weight on the side

and back.

3. If desired a small bead of silicone sealant could be put around the edges of the sink to prevent water seepage

into the spaces below the sink.

Assemble all drain pipe connecons to the tailpiece and on through a pipe trap and proper drainage. The drain

must be installed in accordance with all local codes. In the absence of local codes, the requirements of the Uniform

Plumbing Code should be followed.

INSTALLING THE SINK

INSTALLING THE DRAIN PIPING (NOT SUPPLIED)

INSTALLING THE TRANSFORMER

The power supply transformer should be installed below the sink within the cabinet enclosure. Select a locaon

where the transformer is protected against water, heat and physical damage. It is recommended that fasteners are

used in at least two of the four mounng holes for secure aachment.

The power supply transformer must be plugged into a properly grounded GFI equipped outlet, installed by a

qualied technician. The outlet of the transformer is plugged into the white Molex connector at the rear of the sink.

Please see the electrical diagram provided in this manual.

Faucet installation

instructions available

in the faucet box.