Manual

8
FIGURE 1 (Normal position) FIGURE 2 (Position after door reversal)
1 Top Hinge
2 Screw (3)
3 Door
4 Bottom Hinge
5 Screw (3)
6 Frame
7 Hole Cover
* Insert the lower door hinge in the right side, fix the lower right hinge by tightening all the
screws.
* Remove the pin cap from the right side of the upper frame of the door, and then transfer it to
the same location on the opposite side.
* Put the door on the Lower Door Hinge(5), keep the door level , and then fix the upper hinge(3)
to the body(4) by the screws
* Put on the upper hinge cover(1).
OPERATING YOUR UNIT
Setting the Temperature Control
* Your unit has only one control for regulating the temperature in the compartment. The tempera ture con-
trol is located on the top center of the compartment.
* The first time you turn the unit on, set the temperature control to “5”.
* The range of the temperature control is from position "OFF” to “5”. After 24 to 48 hours, adjust the tem-
perature control to the setting that best suits your needs. The setting of “3” should be appropriate for
normal use.
* To turn the appliance off, turn the temperature control to ”OFF”.
NOTE:
* Turning the temperature control to “OFF” position stops the cooling cycle but does not shut off the
power to the unit.
* If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the unit will not start.