Sedona Cart Assembly

Step 4.
Step 5.
To begin step 4 turn the cabinet upright to secure the
Inner Shelf Assembly. The L400 and L500 shelf will only
assemble as shown at the right with the electrical hole to
the rear and the screws mounting at the back and left
side. The shelf is not only useful but necessary for the
proper stability of the cart. DO NOT omit the inner shelf
or any part in these instructions.
The inner shelf is secured by 4 of the ¼-20 x ½ screws.
Two through the back and two through the left side.
The L600 shelf as shown here will assemble
the same as above.
Step 5 is the last assembly on the L400/L500 cart before
installing the Grill to the cart. The cross brace fits into
recesses located at the front edge of the cart above the
hinge brackets. Orient the brace with the center magnet
facing forward and positioned such that the magnet is
higher than center rather than lower. Install the brace from
the backside of the flanges and align the nutcerts at each
end with the holes provided for the screws. The brace is
secured by 2 of the ¼-20 x ½ screws.
The L600 door frame is attached along with the cross brace .
Support the cross brace from the backside of the front
flanges. Align the nutcerts at each end with the holes
provided for the screws. Position the door frame over the
nutcerts and cross brace , and secure them both with the ¼-
20 x ½ screws.
Step 4.
L400
L500
Step 4.
L600
Step 5.
L400
L500
Step 5.
L600