User Manual

CARE & USE/INSTALLATION
|
6 7
|
CARE & USE/INSTALLATION
USE & CARE GUIDELINES 7
Lynx Grill Models 7
HOW TO LIGHT YOUR GRILL 7
HOW TO LIGHT YOUR ROTISSERIE BURNER 7
BEFORE YOU START 8
If Shipment Arrives Damaged 8
Important Notes 8
Clearance to Combustibles 9
SPECIFICATIONS & INSTALLATION 10
UNPACKING & ASSEMBLY 12
GAS CONNECTIONS 14
Natural Gas 14
LP Gas 15
Gas Conversion Kits 16
ELECTRICAL CONNECTIONS 18
FINAL CHECKS 19
Leak Testing 19
CHECKLIST BEFORE EACH USE 21
A MESSAGE TO OUR CUSTOMERS 21
IMPORTANT SAFETY PRECAUTIONS 22
GRILLING IN WINDY CONDITIONS 23
USING YOUR LYNX GRILL 24
Pre-Grill Checklist 24
Lighting your Grill 25
Basic Grilling 27
Using the Trident ™ Burner 28
Using the Rotisserie Burner 29
Using the Smoker Box 30
CLEANING YOUR LYNX GRILL (Required Maintenance) 31
TROUBLESHOOTING YOUR LYNX GRILL 33
Potential Problems 34
Contacting Lynx Customer Care 37
The Lynx Story 37
LYNX LIMITED WARRANTY 38
LYNX COMMON AREA LIMITED WARRANTY 39
WIRING SCHEMATICS 40-42
L27 & L30 Rotisserie Grill 40
L36 & L42 Rotisserie Grill 41
L54 Rotisserie Grill 42
LYNX PROFESSIONAL GRILLS EXPLODED PARTS VIEW 43
LYNX PROFESSIONAL GRILLS PARTS LIST 44
MODEL-SPECIFIC BTU OUTPUTS & MAX. RUNS FOR APPLIANCES 45
INSULATED JACKET INSTALLATION 46
INDEX 47
TABLE OF CONTENTS
This use & care manual covers the Lynx grill models listed below. Some features and options will vary based upon
the model that you purchased.
LYNX GRILL MODELS
USE & CARE GUIDELINES
BUILT-IN FREESTANDING
L27R-3
L27TR L27TRF
L30R-3
L30TR L30TRF
L36R-3
L36TR L36TRF
L42R-3
L42TR L42TRF
L54TR L54TRF
1. Before each use, refer to the checklist on page 21.
2. Make sure all burner control knobs are in the “OFF” position.
3. Push and hold the control knob in for 5 – 7 seconds, allowing the igniter to heat up.
4. Turn the knob to the “LITE” position.
5. After ignition set the knob to the desired setting.
HOW TO LIGHT YOUR ROTISSERIE BURNER
HOW TO LIGHT YOUR GRILL
Note: The rotisserie burner features a thermocouple sensor with a safety valve that automatically shuts off the
flow of gas if the burner goes out for any reason.
1. Before each use, complete the checklist below.
2. Make sure all burner control knobs are in the “OFF” position.
3. Push and hold the control knob for 5 – 7 seconds.
4. Turn the knob to the “LITE” position and continue to hold the knob in for an additional 30 – 60 seconds to allow
the thermocouple to heat up and keep the safety valve open.