Care And Use / Installation

28
|
INSTALLATION / USE & CARE
ELECTRIC IGNITION
Before proceeding, make sure you have completed the
“Before Each Use” checklist.
Follow these steps to light any of the burners on your grill:
First, make sure all burner control knobs are set to OFF.
For the Main Ceramic
Burner or Trident™ Burner:
Push and hold the control
knob in for 5-7 seconds,
allowing the igniter to heat
up. Then rotate the knob to
“LITE”. After ignition, set the
knob to the desired heat
setting.
For the Rotisserie Burner:
The rotisserie burner features a thermocouple sensor with a
safety valve that automatically shuts o the fl ow of gas if the
burner goes out. (See INDEX: “Windy Conditions” for tips on
how to prevent burner blow out)
To light the rotisserie burner, push and hold the control
knob in for 2 seconds and then turn the knob to the “LITE”
position.
After ignition CONTINUE HOLDING THE CONTROL KNOB IN
for 30 to 60 seconds. During this time the thermocouple will
heat up and the safety valve will remain open.
If you release the control knob before the thermocouple has
heated up, the safety valve will shut o the fl ow of gas to the
rotisserie burner and you will have to re-light the burner.
Extremely cold temperatures may cause your Trident™ burners to light inside the
burners instead of outside. Once lit, if you hear a ‘whooshing’ sound, immediately
turn the burner knobs o to extinguish the fl ame and then immediately re-light
the burners.
COLD WEATHER WARNING:
PROPANE
LI
G
HTIN
G
Y
O
UR
G
RILL
MANUAL LIGHTING
If a burner doesn’t light after several attempts, it can be
match lit using the lighting rod stored in the drip tray.
First, make sure you’ve returned all of the control knobs
to the OFF position and have allowed 5 minutes for any
accumulated gas to dissipate before attempting to match
light a burner.
To match-light this burner, use the lighting rod to insert a lit
match through the cooking grate into the front slot of the
briquette tray for that burner.
Push and turn the corresponding burner control knob to
“LITE”. If the burner doesn’t light within 5 seconds turn the
knob o and wait 5 minutes before attempting to light it
again.
Trident™ Burner
The Trident™ burner does not feature a manual lighting tube.
To match-light this burner, use the lighting rod to insert a lit
match through the cooking grate and through the protective
screen.
Push and turn the corresponding burner control knob to
“LITE”. If the burner doesn’t light within 5 seconds turn the
knob o and wait 5 minutes before attempting to light it
again.