Care And Use / Installation

24
|
INSTALLATION / USE & CARE
FINAL
C
HE
C
K
S
...
c
o
n
t
in
u
e
d
BURNER FLAME ADJUSTMENT
Each grill burner is tested and adjusted at the factory prior
to shipment. However, fl uctuations in gas pressure, gas
conversion and even in the quality of the gas itself may make
it necessary to adjust the burner.
Flames should be blue and stable with slight yellow tips. The
bright-blue core should be about 3/8 inch high with a total
fl ame height of about 1 1/2 inches.
The fl ames should burn quietly (no “torch” sounds) and they
should not “lift” up from the burner.
If your fl ames do not match those indicated in the photo,
ensure that burner ports are free and clear of dirt, debris, or
spider webs.
The appearance of the Trident™ burner should be visually
checked. The ceramic tiles should be uniformly red to
orange in appearance. There should be no lifting, fl uttering
or lazy blue fl ames. Some food particles will show as yellow
fl ames but should burn o .
ONE LAST THING
Finally, before leaving, check all the burners for proper
operation. Make sure the control knobs turn freely and
completely through their full range.
IMPORTANT:
Make sure the owner knows where the main gas supply shut
o valve is located.
Finally, for safety and for proper use & care, you must leave
this manual with the owner. Make sure you advise them to
keep it for future reference.
For technical assistance call:
Lynx Customer Care
888-289-5969
• Do you smell gas? If yes, shut o everything and call the
gas company or a qualifi ed plumber to check for leaks, if
not please continue.
• Are you prepared to stay with the grill during the entire
cooking process? If not, gather what you need before
starting the lighting process. If yes, please continue.
• Is your cooking area free and clear of any combustibles,
besides your food, that might ignite? If not, clear the area
before starting the lighting process, If yes, please continue.
• Do all control knobs turn freely? If not, call for service, if
yes, please continue.
• If you are using a portable propane cylinder, is it connected
and leak tested? If not, check the connection before
continuing. If yes, please continue.
• Do you know where your grill’s main gas supply shut o
valve is located? If not, locate it before continuing. If yes,
please continue.
• Are all burners properly seated in the grill with mounting
legs in slots? If not, seat the burners properly before
continuing. If yes, please continue.
• Is the wind blowing just lightly and not blowing on the back
of the grill? If not, wait until the wind subsides or turn your
free standing grill so the wind goes into the front of the grill.
If yes, please continue with the lighting process.
CHECKLIST BEFORE EACH USE
FOR YOUR SAFETY