Care And Use / Installation

20
|
INSTALLATION / USE & CARE
G
AS CONNECTIONS
...
co
n
t
in
u
e
d
Insert the regulator inlet into the cylinder valve and turn the
black coupler clockwise until the coupler is hand tight. Do
not over-tighten this connection.
To disconnect the coupler, fi rst make sure the main cylinder
valve is turned o . Grasp the coupler and turn counter
clockwise. The inlet will then disengage.
Always leak-test the connection after refi lling or exchanging
LP cylinders. (See INDEX: “Leak Test” for further details.)
GAS LINE PURGING
You should purge the gas line of air before attempting to
light the grill.
• Make sure all grill controls are in the “OFF” position.
• Slowly turn on the main gas supply.
• Push in the rotisserie knob and confi rm that the igniter
is glowing. It is furthest from the fuel source and will
completely purge the lines. It will take several seconds for
the burner to light.
• Hold the knob ON for about 20 seconds to allow the air in
the system to purge and the burner to light
• Wait at least 5 minutes after shutting o the control before
attempting to light the burners.
GAS CONVERSION KITS
Gas conversion kits are available from Lynx Grills to allow
the grill to operate on either Natural gas or LPG. These kits
should be installed by a qualifi ed technician.
The kits come with complete installation instructions. These
instructions should be read completely and fully understood
before installing the conversion kit.
LP CONVERSION KI
T
NG CONVERSION KI
T
N
G
AND BULK LP BUILT-IN INSTALLATION
•
S
hut o

the gas supply at the main valve
.
•
I
f
connecting to a bulk propane tank, disconnect the
b
rass elbow, hose and regulator
f
rom the grill.
•
Remove all
fi
ttings
f
rom the grill mani
f
old.
•
C
onnect the
g
as suppl
y
to the
g
rill as shown in the
d
ia
g
ram on t
h
is pa
g
e
.
•
Turn the gas supply on and leak test all connections.
(
See
INDEX:
“
Leak Test
”
f
or
f
urther details
.
Never run
fl
ex hose behind the
fi
rebox. Run the hose at an
a
ngle, straight down or out o
f
the bac
k
Inline Regulator
1/2” MxF
Street
Elbow
Angle At Least
20˚ From Horizon
Grill Manifold
1/2” MIP
Fitting
Flexible Gas Line to Inlet