Use and Care Manual

12
|
CARE & USE/INSTALLATION
UNPACKING & ASSEMBLY
Use two or more people to move or install this
unit. Failure to follow this instruction can result in
back or other personal injuries.
WARNING:
EXCESSIVE WEIGHT HAZARD!
Grill will not slide directly off pallet.
The grill arrives nearly ready to use and requires only minor
assembly.
By carefully following the uncrating and unpacking steps,
you will improve the customer’s first Lynx experience.
Shipping weight on smaller units is app. 300 pounds and
larger units may weigh over 500 pounds.
CRATE & CARTON
• IMPORTANT! Do not remove staples around the top of
the carton. These staples hold a wooden pallet in place
inside the carton that protects the unit from damage.
Removing these staples may cause the pallet to fall on
the top of grill.
How to Remove the Carton
• Cut the main strap holding the grill to the pallet.
• Remove the staples at the bottom of the carton.
• Lift off the carton. There is a pallet over the grill for hood
protection.
• With assistance, remove the grill from the pallet and
place into desired location.
The wheels sit down in the gaps of the shipping crate so
that the grill can sit safely and solidly on the crate during
shipping. The grill cannot be slid directly off of the pallet.
One way to safely move the grill off of the pallet is by lifting
one end of the grill high enough to place a ramp under the
wheel and then lift the other end while rolling the grill off of
the pallet.
When pushing, lifting, or pulling a freestanding Lynx Grill
across gravel, grass, pavers, brick, stone, imperfections in
the surface, or wood slatted decks be cautious and move
slowly or use a carpet dolly. Failure to do so may damage
the structure of the cart which will not be covered under
warranty.
INTERIOR PACKING
Lynx uses sturdy tie-down cables and straps to ensure
your grill arrives at your home in the same condition that
it left our factory. BE SURE YOU HAVE REMOVED ALL TIE
DOWNS BEFORE USING YOUR GRILL.
• Remove the white accessory box and wood packing, the
grill racks, and remove any loose items from the firebox.
• Carefully cut the cable ties
securing the warming rack
and rotisserie spit.
• Trident ™ burner, cut and
remove ties from the burner
partition of the Trident ™ burner.