L24TWS & L24TWD Care & Use
L24TWR Tower Kit - Mounting your kit directly to an island.
1) Determine the location of the refrigerator in the island installation. It should be positioned nearly flush to the face
surface of the island for easy access and alignment with the tower. The refrigerator cavity should be 35” high x 24-
1/2” wide x 26” deep.
2) Position the refrigerator in the island opening at the exact position. Open the door and make a reference mark on the
underside of the countertop at the face of the open refrigerator. This surface represents the best guide for locating the
hole in the countertop. Each refrigerator door is custom set at the factory for the best seal. The face of the closed door
varies slightly from unit to unit. DO NOT use the closed door surface as a reference.
3) Remove the refrigerator from the cabinet while drilling the holes for mounting. Using the diagram at the bottom of this
page as a guide, mark the center of a 2” diameter hole and drill through the countertop for the beverage line.
4) Locate and drill the 4 mounting holes to secure the keg tower.* Four
#12 screws have been provided. A ¼” diameter hole is sufficient for
these bolts. If another securement method (i.e. lead anchors) are used,
follow the manufacturers recommendations.
5) A flush mount drip tray is provided as an option. Refer to the diagram
below and cut the opening required if this option is to be installed.
6) Prepare the tower assembly for installation. A 14 inch length of
insulating foam has been provided to install inside the tower base. The
installation of this foam is critical to the proper operation of the
beverage tower kit. Failure to properly insulate the tower base could
cause excessive foam and incorrect temperature control. Insert the
foam around the beverage line and insert it into the beverage tower
with about 2” protruding from the base.
7) Place the large flat rubber gasket over the hole in the countertop.
8) Feed the beverage tube into the hole in the countertop
9) Align the gasket and secure the tower to the countertop with the 4
screws provided. From the underside insert the washers and nuts.
Tighten the screws completely.
10) Remove the black plastic plug from the top center of the refrigerator.
Keep in a safe place for future use.
11) Bring the beverage tube out to the front of the opening designed for
the refrigerator. Begin to slide the L24BF refrigerator into the opening.
Before the refrigerator is halfway into position, feed the beverage tube
through the hole in the top. Alternately slide the refrigerator back and
draw the tube into the refrigerator to remove any kinks in the hose.
When finished, the hose should align like the illustration on the right.
12) Add the tap and handle with the wrench provided.
13) Insert the spill tray into the countertop.
* Before drilling
mounting holes,
position the tower on
the counter top to
ensure proper tap
alignment. Holes may
be drilled out to ½” to
provide additional
adjustment.
insulation
counter
Beverage
Tube
L24BF Width
13 11/16
13 11/16