Care and Use Manual

Connecng the Keg to the Beverage Tower.
1. Aach the clear hose from the beverage tower to
the barbed ng with the hose clamp provided.
Insert the rubber washer provided into the
ng.
2. An elbow is included to provide addional
space above the keg coupler. Secure the
elbow to the top outlet of the keg coupler
with a washer between. Aach the clear hose
ng, with washer, to the elbow. Use a
wrench to ghten the connecons.
3. The colored hose line is installed onto the side
barbed ng of the keg coupler and the
barbed ng below the CO
2
regulator. Press
the tube onto the ngs and secure with the
two hose clamps. Refer to the instrucons
provided with the CO
2
tank before aaching
the tank to the regulator.
4. With the regulator and tank in the OFF posion,
aach the regulator securely to the CO
2
tank with a
wrench.
The Kit is Ready to Aach a Keg.
The Beverage Tower Kit is provided with a standard D Style coupler.
This style is appropriate for most domesc beers. Addional styles are
available from restaurant supply or beverage companies.
Ball Valve
1. Insert the CO2 canister in the rear le shelf inside the refrigerator.
2. Place the beer keg inside the refrigerator and arrange all hoses such that none are pinched.
3. Slowly open the main valve on the CO2 canister. Check for leaks.
4. Slowly open the regulator ball valve to pressurize the keg.
5. Toggle the tap handle on the tower to dispense a small amount of liquid. This will “charge the
system”.
6. Adjust the T-handle on the regulator to between 8 and 14 PSI. The pressure seng will vary for
beer type and keg style. Refer to the troubleshoong guide and experimentaon to set the pressure
accordingly.
7. Allow the system to rest for several hours before use. Temperature and pressure are crical to
sasfactory results.
Operang the Beverage Tap:
Use supplied hose
clamps here
1. Align lug locks on coupler with lug
housing in top of keg; insert coupler.
2. Turn coupler ¼ turn
clockwise; the coupler is
now secured to keg.
3. Push down on the coupler
and give another ¼ turn, to
open beer and CO
2
ports in keg.
The keg is now tapped.
CO
2
Tank Level
Main Valve
8-14 PSI
T-Handle