Care and Use Manual

L24TWS Tower Kit - Mounng your kit directly to an island.
1. Determine the locaon of the refrigerator in the island installaon. It should be posioned nearly ush to the face surface of
the island for easy access and alignment with the tower. For the refrigerator cavity height and depth, please refer to the
cutout for your individual model (L24BF/LM24BF).
2. Posion the refrigerator in the island opening at the exact posion. Open the door and make a reference mark on the
underside of the countertop at the face of the open refrigerator. This surface represents the best guide for locang the hole
in the countertop. Each refrigerator door is custom set at the factory for the best seal. The face of the closed door varies
slightly from unit to unit. DO NOT use the closed door surface as a reference.
3. Remove the refrigerator from the cabinet while drilling the holes for mounng. Using the diagram at the boom of this page
as a guide, mark the center of a 2” diameter hole and drill through the countertop for the beverage line.
4. Locate and drill the 4 mounng holes to secure the keg tower.* Four #12
screws have been provided. A ¼” diameter hole is sucient for these bolts. If
another securement method (i.e. lead anchors) are used, follow the
manufacturers recommendaons.
5. A ush mount drip tray is provided as an opon. Refer to the diagram below
and cut the opening required if this opon is to be installed.
6. Prepare the tower assembly for installaon. A 14 inch length of insulang
foam has been provided to install inside the tower base. The installaon of
this foam is crical to the proper operaon of the beverage tower kit. Failure
to properly insulate the tower base could cause excessive foam and incorrect
temperature control. Insert the foam around the beverage line and insert it
into the beverage tower with about 2” protruding from the base.
7. Place the large at rubber gasket over the hole in the countertop.
8. Feed the beverage tube into the hole in the countertop
9. Align the gasket and secure the tower to the countertop with the 4 screws
provided. From the underside insert the washers and nuts. Tighten the
screws completely.
10. Remove the black plasc plug from the top center of the refrigerator. Keep in
a safe place for future use.
11. Bring the beverage tube out to the front of the opening designed for the
refrigerator. Begin to slide the refrigerator into the opening. Before the
refrigerator is halfway into posion, feed the beverage tube through the hole
in the top. Alternately slide the refrigerator back and draw the tube into the
refrigerator to remove any kinks in the hose. When nished, the hose should
align like the illustraon on the right.
12. Add the tap and handle with the wrench provided.
13. Insert the spill tray into the countertop.
* Before drilling mounng holes,
posion the tower on the counter
top to ensure proper tap
alignment. Holes may be drilled
out to ½” to provide addional
adjustment.
LYNX MODEL LM24BF
OUTDOOR REFRIGERATOR
(UNDER ISLAND COUNTER TOP)