Manual

Introducon:
Your Lynx Beverage Kits comes with all of the components necessary to install a keg tap and tray to an outdoor
island or to the Lynx model L24BF or LM24BF outdoor refrigerators.
The Lynx model L24BF and LM24BF outdoor refrigerators have been designed specically to work with the Beverage
Kits.
The L24BF refrigerator cavity is designed to accommodate two 1/6 kegs, or all single standard keg sizes except a ½
keg or larger (not provided), the CO
2
tank and required connecons.
The LM24BF refrigerator cavity is designed to accommodate all single standard keg sizes (not provided), the CO
2
tank and required connecons.
Please note in some cases you may need to use sealing gum to seal around the opening at the top of the refrigerator.
Warning:
CO
2
cylinders contain high pressure gas which can be hazardous if not handled properly. Make sure you READ and
UNDERSTAND the procedures regarding the CO
2
cylinders BEFORE installaon.
Safety First:
How to install a CO
2
Regulator or replace an Empty CO
2
Cylinder
1. To shut o gas pressure to dispenser always close cylinder valve “A”
2. Shut o outlet ng “C” if regulator is equipped with one.
3. Back out (counterclockwise) regulator adjusng screw “B” as far out as it will
go. (The regulator is now in the o posion).
4. Remove regulator from empty cylinder at “E”.
5. Remove dust cap from new cylinder at “E”. Open and close valve “A” quickly to
blow dust from outlet.
6. With cylinder valve “A” in closed posion, re-aach regulator to cylinder a “E”.
Use a plasc or ber CO
2
washer to couple regulator to cylinder.
7. Open valve “A” all the way. (This is important because this cylinder valve seals
in two places).
8. Make certain outlet is closed at “C”.
9. Turn regulator adjusng screw “B” in (clockwise) unl required pressure is
reached “D”.
10. Open outlet valve “C”.
A CO
2
cylinder contains extremely high pressure regardless of size, and therefore
should be handled with care!
C
B
D
E
A
CO
2
Safety
Device