Installation

Installation of Your Lynx

Beverage Tower Base

Lynx Beverage Tower Base - Model L24TWB

Introduction:

Your Lynx Beverage Tower Base is an accessory that allows either the Lynx Single Tap

(L24TWS) or Lynx Double Tap (L24TWD) to be used with the Lynx model L24BF outdoor

refrigerator. An optional caster kit is available to set this kit up as a mobile beverage station

when used with the L24BF. The Tower Base may also be installed onto a countertop.

The Lynx model L24BF outdoor refrigerator has been designed specifically to work with the

Beverage Kits. The volume is designed to accommodate two standard US quarter beer kegs

(not provided), the CO2 tank and required connections.

WARNINGS:

CO2 cylinders contain high pressure gas which can be hazardous if not handled properly.

Make sure you READ and UNDERSTAND the procedures included with the CO2 cylinders

BEFORE installation.

L24TWB shown with

the L24TWS on the

L24BF Refrigerator

Lynx Grills, Inc. | 6023 E. Bandini Blvd. Commerce, CA 90040 | Phone: (323)838‐1770 Fax: (323)838‐1778 | www.lynxgrills.com

L24BF Refrigerator

and L24CST Caster kit

(Each sold

Separately).

PAGE 1
Installation of Your Lynx Beverage Tower Base Lynx Beverage Tower Base - Model L24TWB Introduction: Your Lynx Beverage Tower Base is an accessory that allows either the Lynx Single Tap (L24TWS) or Lynx Double Tap (L24TWD) to be used with the Lynx model L24BF outdoor refrigerator. An optional caster kit is available to set this kit up as a mobile beverage station when used with the L24BF. The Tower Base may also be installed onto a countertop.
PAGE 2
L24TWB Tower Base - Direct mounting to the L24BF Refrigerator. 1) Remove the black plastic plug from the top center of the refrigerator. Keep in a safe place for future use. 2) Place the large flat rubber gasket over the 2-1/2” hole in the tower base. 3) Prepare the tower assembly for installation. A 14 inch length of insulating foam has been provided to install inside the tower base. The foam must protrude through the tower base into the refrigerator to make a proper seal.