Care & Use

Lynx Grills Inc.
.
Page 6
Base Grill
To Remove and Replace the Base Grill:
1. Open the appliance door and remove the base grill by pulling down and out from the top.
2. Replace the base grill by putting the clips in the openings in the appliance panel. Push in until the base grill snaps into place.
Changing the light bulb
NOTE: Not all appliance bulbs will fit your appliance. Be sure to replace the bulb with one of the same size, shape, base size and
wattage. You should be able to locate a bulb at a local hardware store, it is a T7 base
and must not exceed 15 watts. If you
cannot locate a bulb locally you can order one by calling Lynx Grills at 1-888-289-5969. It is part no. 33015.
1. Unplug appliance or disconnect power.
2. Remove the light shield.
3. Replace the light bulb with an appliance bulb of the same wattage.
4. Replace the light shield.
5. Plug in appliance or reconnect power.
Loss of Power
After the power is restored, unplug the appliance for 30 minutes, to allow the refrigeration system to equalize. During this time
keep the door closed whenever possible.
REMEMBER: A full appliance stays cold longer than a partially filled one.
Moving Care
1. Remove all containers.
2. Unplug the appliance.
3. Clean it thoroughly.
4. Tape the appliance shut and tape the electrical cord to the cabinet.
When you get to your new location, refer to the “Installation Instructions” and “Appliance Use” sections for information
on installation and setting the controls.
APPLIANCE OPERATION