Care & Use

Lynx Grills Inc.
.
Page 4
CHOOSING THE RIGHT PLACE
Place the appliance in a dry and regularly ventilated place. It is recommended that this appliance always be operated in an ambient
temperature of at least 60°F and under 85°F. The appliance may be exposed to lower or higher temperatures but only for a short period of
time and the temperature should never be lower than 45°F. Never place the appliance near heat emitting devices (e.g. cooker, radiator,
water heater or similar devices) and avoid exposing it to direct sunlight.
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz. AC only 15- or 20- amp fused or circuit breaker, grounded electrical supply is required. It is recommended that a separate
circuit serving only your appliance be provided. Use outlets that cannot be turned off by a switch or pull chain. Connect this appliance to a 3
prong power supply socket outlet (which has a ground terminal). If you only have a two prong outlet have it replaced by a qualified technician
with an outlet that meets the local codes. “DO NOT USE AN EXTENSION CORD.” Required nominal voltage and frequency are indicated
on the rating plate. The connection to the power supply and grounding has to be made according to current standards and regulations. The
appliance resists temporary voltage tolerance from -15 to 10%.
IMPORTANT
Electrical Shock Hazard. * Plug into a grounded 3 prong outlet. Do not remove ground prong. * Do not use an adapter.
Do not use an extension cord. * Failure to follow these instructions can result in death, fire, or electrical shock.
A GFCI (ground fault circuit interrupter) is built into every line cord. Do not defeat or bypass this important safety feature. The line cord
supplied with this appliance is specially designed for outdoor use. Use only a factory supplied replacement cord with a GFCI
(ground fault circuit interrupter) in the event the cord becomes damaged.
ENERGY SAVING TIPS
 The more airflow you can provide around an appliance, the less energy it will use.
 If your appliance needs defrosting, keep ice build-up to less than 1/2 inch.
 Keep the door open a minimum of time, and shut securely.
1. Locate the two front leveling legs mounted into the underside of the appliance.
2. Adjust the front legs just enough to lift the cabinet up off of the floor.
3. Place a leveling tool on top of the appliance first side to side, then front to back. Turn leg counterclockwise to raise a corner. Turn leg
clockwise to lower a corner.
4. Once you have achieved side to side level, increase the front to rear adjustment to be slightly higher at the front. This will ensure the door
closes automatically once it is released. Increase the front to rear adjustment until the door self-closes.
6. After appliance is fully loaded, recheck with level as in Step 4.
LEVELING YOUR APPLIANCE
INSTALLATION INSTRUCTIONS