Care & Use

Lynx Grills Inc.
L24REF
Page 3
Excessive Weight Hazard! * Use two or more people to move and install your appliance.
Failure to do so can result in back or other injury.
ALLOW APPLIANCE TO SIT UPRIGHT FOR 24 HOURS BEFORE TURNING ON, TO ALLOW THE
COMPRESSOR LUBRICANT TO DRAIN.
1. Remove Packaging Materials
2. Remove tape and glue residue from surfaces before turning on the appliance. Rub a small amount of liquid dish
soap over the adhesive with your fingers. Rinse with warm water and dry.
3. Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue.
These products can damage the surface of your appliance.
4. When Moving Your Appliance:
Your appliance is heavy. When moving the appliance for cleaning or service, be sure to protect the floor. Always pull
the appliance straight out when moving it. Do not wiggle or “walk” the appliance when trying to move it, because floor
damage can occur.
5. Clean Before Using
After you remove all of the packaging materials, clean the inside of your appliance before using it. See the cleaning
instructions in “Appliance Care.”
6. This model has leveling legs. Level as necessary for best operation.
7. If you are using a caster kit ensure wheels are locked once the refrigerator is located.
Keep flammable materials and vapors, such as gasoline, away from appliances. Failure to do so can result in
death, explosion, or fire.
IMPORTANT: Do not install the appliance near an oven, radiator, or other heat source, nor in a location where the
temperature will fall below 40°F (5°C). Attempt to keep out of direct sunlight.
Check the strength of the floor before installing your appliance. It should hold the weight of a fully loaded appliance.
Allow at least 1” (2.5 cm) of airspace at the top and on both sides of the appliance and 1” (2.5 cm) between the back
of the appliance and the wall. If the appliance is going to be placed against a wall, leave extra space on the hinge
side so the door can open wider than its width.
NOTE: This appliance may be installed side by side with another appliance or appliance. Allow for a 3’ (7.5 cm)
clearance at the top and sides and a ¼” (0.64 cm) clearance between the appliances.
IF YOUR LYNX REFRIGERATOR IS DESIGNED FOR BUILT IN USE, AND DOES NOT REQUIRE CLEARANCE
EXCEPT IN THE BACK. BE SURE THAT YOU DO NOT BLOCK THE AIRFLOW UNDER THE APPLIANCE .
INSTALLATION INSTRUCTIONS
LOCATION REQUIREMENTS
UNPACKING