Operation Manual

Page 44
4.5.7 Power Up State
Hilo can be set to toggle between two power up states:
Standby: In this mode, when AC power is applied and the back panel power switch is in the
ON position (show graphic), Hilo will be in Standby mode until the front panel STANDBY
switch is pressed. Then the Hilo will power up and be ready for use.
On: In this mode, when AC power is applied and the back panel power switch is in the ON
position, Hilo will power up and be ready for use. This is a typical setting when Hilo is
placed in an equipment rack with a single master power switch for all of the equipment in the
rack.
4.6 Information Page
As with the Tools page, there are several open buttons for future features.
Another advantage of the Touch Screen is that status information can be quickly accessed. This information tells you
what is going on “under the hood” of Hilo and provides crucial data for trouble shooting in the field.
All Information pages will stay open until you tap “Close”, or the Meter screen comes up based on the “Return to
Meters” delay time established in the DISPLAY CONTROLS page.