Cocktail Station Pro Care & Use

Installation Instructions CS30-1 and CS30F-1
• Remove any protective wrapping
• Remove the speed rail, ice bin cover, bottle cap holder, faucet and water filter
assemblies, water filter holder and cutting board from the inside of the ice bin
• Assemble the faucet assembly and place into the mounting hole at the rear of the
sink and secure it in place with the lock nuts provided
• Position the cocktail pro CS30-1 in the island cutout (Does not apply to the
CS30F)
• Install a PVC drain line to the 1½” brass drain of the ice bin and sink. These may
be connected to single drain. Extend the drain line through the back of the island,
or out of the lower rear panel of the CS30F-1.
• Locate a convenient place below the CS30-1 and mount the water filter holder,
attach the flexible water tubing to the faucet inlet. Key lock studs are provided in
the cabinet below the CS30F-1 to mount the water filter holder
• Install the cold water line to the inlet side of the water filter or a garden hose may
be used.
• Once in place the CS30-1 cocktail pro can be sealed to the counter top using
clear, all-weather silicone sealant
• Remove protective wrapping from the speed rail, bottle cap holder, ice-bin cover
and cutting board
• Hang the speed rail and bottle cap holder from the front of the cocktail pro using
the key-lock studs
• Place the two piece sliding ice bin cover on the ice bin rail and place the cutting
board on the front of the sink’s drain board
• To install the Pass Shelf refer to the instructions accompanying the assembly