User Manual

Page 29
level of that source before it is sent to the output. This mode would be typical for live use, where making an input
source live at full volume could have ear-shattering consequences.
For the remainder of this section, when mention is made of enabling sources whether this is accomplished by the
Single Tap method (Single Tap Source Select = ON) or Two Tap (Single Tap Source Select = OFF) will be left up to
the reader.
3.4.8.3 Selecting Monitor Sources
Returning to the default Output Mix Routing page, let’s say that
we wanted to add Digital In as a source to route to the Line Out.
We could simply enable the Digital In with either a single-tap or
double-tap and the page would now look like this.
In this state, audio streaming from USB Play 1&2 will be merged with audio streaming from the Digital Input. One
must be cautious of the levels of each source in this case, as the combined signal strength could cause clipping to the
output. If this occurs, it can be remedied by attenuating the faders for the input sources (USB Play 1&2 and Digital In),
or by attenuating the associated output.
Now if we wish to listen to the Digital In signal through Line
Out but NOT the USB Play 1&2 signal, we could turn the USB
Play 1&2 button off, again via the one-tap, or two-tap method.
Using either method, the result would be Digital In as the only
source feeding Line Out. It would look like this.