User Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started Aurora(n)-USB
- 3 Getting Started Aurora(n)–TB3 (Thunderbolt)
- 4 Getting Started Aurora(n)-DNT (Dante)
- 5 Getting Started Aurora(n)-HD2 (ProTools HD)
- 6 Front Panel Controls
- 6.1 Meter Page
- 6.2 Function menu
- 6.2.1 Clock Setup
- 6.2.2 Line Trim
- 6.2.3 Preamp
- 6.2.4 Preamp Setup
- 6.2.5 Routing
- 6.2.6 Test Tone
- 6.2.7 Digital In Status
- 6.2.8 Optical Settings
- 6.2.9 SD Card
- 6.2.10 SD Record Setup
- 6.2.11 Sessions
- 6.2.12 Takes
- 6.2.13 Scenes
- 6.2.14 Playlists
- 6.2.15 Settings
- 6.2.16 Date & Time
- 6.2.17 Backlight
- 6.2.18 About
- 6.2.19 Firmware Update
- 6.2.20 USB Mode
- 6.3 Phones Source (Basic)
- 6.4 Phones Source (Advanced)
- 7 microSD Record and Play basics
- 8 Firmware Updates
- 9 Support
- 10 Troubleshooting & User Tips
- 11 Specifications
- 12 Aurora(n) Performance Measurements
- 13 Certifications
- 14 Warranty Information
38
Select the “OK” indicator and press Select. The firmware update will progress through four stages:
Erasing, Programing, Verifying, Complete
When the firmware update is complete, the following page will appear:
To complete the update process, simply turn the power off using the front panel power switch. Once you turn
the power back on the new firmware should be active.
6.2.20 USB Mode
The Aurora
(n)
-16 USB has a unique page to itself. The LT-USB can operate in two different modes, 8-
Channel and 16-Channel. In 8-Channel mode, 192kHz operation is possible, however in 16-Channel mode
96kHz is the maximum sample rate. This page allows switching between the two modes. Please note that
changing the setting will reset the computer connection, so should be done when audio applications are
closed.