User Manual

30
If the DB-ADAT module is installed, the Optical Input status will also be shown.
6.2.8 Optical Settings
The “Optical Settings” page is available if the LM-DIG + DB-ADAT combination are installed in the
Aurora
(n)
. This setting allows the Optical Output to be changed to either ADAT or SPDIF mode, or to have
the Optical Output format follow the same format as Optical Input 1 (which is the default).
6.2.9 SD Card
The “SD card” page shows the characteristics of any inserted microSD card. The label assigned to the card,
the File system used (FAT32 and exFAT are both supported), Capacity, Free space and Used space are
displayed in bytes (for example 17,179,869,184 = 16GB). When the Free space is less than 18,432,000 bytes
(one second for 32-channel / 192kHz, just over one minute for 2-channel / 44.1kHz) the Record button will go
out and new recordings will not be possible on that microSD card until it is cleared of all files and formatted.
PLEASE NOTE: FAT32 has a 4GB file size limitation. Lynx recommends that you always format the
microSD card using the exFAT file system to overcome this limitation regardless of microSD card size.
Normally a microSD card that is 32GB or smaller will default to FAT32 file system. Using your computer to
format the microSD Card, simply select exFAT as your file system from the Format or Erase dialog box.
Below are screen-shots showing where those selections are made from Windows (left) and macOS (right).