User Manual

23
6.1.2 Horizontal Meter
The horizontal meters show greater detail for two pairs of channels on the Aurora
(n)
. Level markers and clip
indicators make this a useful tool for calibration and troubleshooting.
Press the Select button to choose which sources drive both sets of meters:
The “Meter Select” page operates a bit differently from other pages on the Aurora, since there are more
options here than other pages.
• Select between the “Top Meter” and “Bottom Meter” choices with the Up or Down Arrow buttons,
respectively. Both buttons turn cyan to indicate the special purpose for these buttons while in the Meter
Select page.
• The Function button will allow you to choose the source category, between “Line In”, “Line Out”, “AES
In’, “AES Out” (if available), “Preamp” (if available), “USB / Thunderbolt / Dante / HD”, and “Phones”.
If the LM-DIG + DB-ADAT combination are installed, the “AES In” / “AES Out” can be changed to
“ADAT In” / “ADAT Out” by pressing and holding the Function button for ½ second. The color of the
Function button turns Blue when the AES or ADAT are selected to indicate that a special purpose is
available for this button.
• The Rotary Encoder lets you scroll to the specific channel pair you desire, and then either press the
Rotary Encoder, or the Select button, to make your choice.
Press Meters/Exit button to exit this page.
6.2 Function menu
This is the logical place to start for primary set up and configuration of your Aurora
(n)
. Opening the
“Function” menu is simply a matter of pressing either the Function button when on the meter page.