User Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started Aurora(n)-USB
- 3 Getting Started Aurora(n)–TB3 (Thunderbolt)
- 4 Getting Started Aurora(n)-DNT (Dante)
- 5 Getting Started Aurora(n)-HD2 (ProTools HD)
- 6 Front Panel Controls
- 6.1 Meter Page
- 6.2 Function menu
- 6.2.1 Clock Setup
- 6.2.2 Line Trim
- 6.2.3 Preamp
- 6.2.4 Preamp Setup
- 6.2.5 Routing
- 6.2.6 Test Tone
- 6.2.7 Digital In Status
- 6.2.8 Optical Settings
- 6.2.9 SD Card
- 6.2.10 SD Record Setup
- 6.2.11 Sessions
- 6.2.12 Takes
- 6.2.13 Scenes
- 6.2.14 Playlists
- 6.2.15 Settings
- 6.2.16 Date & Time
- 6.2.17 Backlight
- 6.2.18 About
- 6.2.19 Firmware Update
- 6.2.20 USB Mode
- 6.3 Phones Source (Basic)
- 6.4 Phones Source (Advanced)
- 7 microSD Record and Play basics
- 8 Firmware Updates
- 9 Support
- 10 Troubleshooting & User Tips
- 11 Specifications
- 12 Aurora(n) Performance Measurements
- 13 Certifications
- 14 Warranty Information
22
All I/O Meter on an Aurora
(n)
with 16 line i/o and
Thunderbolt.
All I/O Meter on an Aurora
(n)
with 24 line i/o and
Thunderbolt combined on one page.
All I/O Meter on an Aurora
(n)
with 24 line i/o (LSlot
channels are shown on a separate page).
All I/O Meter on an Aurora
(n)
with 32 line i/o.
All I/O Meter on an Aurora
(n)
PRE1608 with
Thunderbolt combined on one page.
All I/O Meter on an Aurora
(n)
with 16 line i/o and
LM-DIG.
Pressing Meter/Exit button changes to AES and
ADAT on an Aurora
(n)
with LM-DIG and DB-
ADAT.
Pressing Meter/Exit button changes to
Thunderbolt/USB/Dante/HD.