User's Manual

8.1.1. Default UART Interface Settings
Parameter
Setting
Baud Rate
115200
Data Bits
8
Parity Bit
None
Stop Bit
1
Flow Control
None
8.2. Interrupt Pins
Four mappable interrupt pins are available based on application specific requirements. The
available modes are detailed in the following table.
8.2.1. Interrupt Functions
Signal
Type
Read data available
Output
Transmit queue empty
Output
Service queue empty
Output
Transmit active
Output
Receive active
Output
Network in sync
Output
Transmit buffer full
Output
Interference detected
Output
Service ACK received
Output
Service ACK time-out
Output
High priority alert
Output
Receive Ready
Output
8.3. Antenna Pin
Pin 18 on the LNQNSM01 connects to a 915 MHz antenna. It is matched to 50 Ohms. To maximize
performance, it is important to make sure that any traces from the pin are matched to 50 Ohms.
8.4. nReset Pin
Antenna model:LNQNSM01
Antenna type:PCB
Antenna gain:0dBi
Manufacturer:LYNQ Technologies, Inc.