Use Instructions
Table Of Contents
- 1 About this document
- 2 Product Overview
- 3 Interface Description
- 3.1 PIN Definition
- 3.2 Operating condition
- 3.3 Digital I/O characteristics
- 3.4 Power Interface
- 3.5 UIM interface
- 3.6 PCM interface(TBD)
- 3.7 USB2.0 interface
- 3.8 UART Interface
- 3.9 Power on/off and reset interface
- 3.10 Interactive interface
- 3.11 Net Light interface
- 3.12 System boot configuration and download
- 3.13 Analog and Digital conversion (ADC) interface
- 3.14 I2C interface
- 3.15 SPI interface
- 3.16 Antenna interface
- 4 Product characteristics
- 5 Design guideline
- 6 Manufacturers
- 7 Package Storage information
- 8 Safety Information
L710HG Hardware Design
6
8
《L710HG_V1_DECAL.PCB》
1.4 Terms and Abbreviations
Table 1-2 is the Document relative Terms and Abbreviations。
Table 1-2 Terms and Abbreviations
Abbreviation
Descriptions
ESD Electro-Static discharge
USB Universal Serial Bus
UART Universal Asynchronous Receiver Transmitter
SDCC Secure Digital Card Controller
USIM Universal Subscriber Identification Module
SPI Serial Peripheral Interface
I2C Inter-Integrated Circuit
PCM Pulse-coded Modulation
I/O Input/output
LED Light Emitting Diode
GPIO General-purpose Input/Output
GSM Global Standard for Mobile Communications
GPRS General Packet Radio Service
WCDMA Wideband Code Division Multi Access
UMTS Universal Mobile Telecommunication System
HSDPA High Speed Downlink Packet Access
HSUPA High Speed Uplink Packet Access
AGPS Assisted Global Positioning System
BER Bit Error Rate
DL Downlink
COEX WLAM/LTE-ISM coexistence
SMPS Switched-mode power supplies
LTE Long Term Evolution
FDD Frequency Division Duplexing