Use Instructions
Table Of Contents
- 1 About this document
- 2 Product Overview
- 3 Interface Description
- 3.1 PIN Definition
- 3.2 Operating condition
- 3.3 Digital I/O characteristics
- 3.4 Power Interface
- 3.5 UIM interface
- 3.6 PCM interface(TBD)
- 3.7 USB2.0 interface
- 3.8 UART Interface
- 3.9 Power on/off and reset interface
- 3.10 Interactive interface
- 3.11 Net Light interface
- 3.12 System boot configuration and download
- 3.13 Analog and Digital conversion (ADC) interface
- 3.14 I2C interface
- 3.15 SPI interface
- 3.16 Antenna interface
- 4 Product characteristics
- 5 Design guideline
- 6 Manufacturers
- 7 Package Storage information
- 8 Safety Information
L710HG Hardware Design
29
TXD1
RXD1
RTS1
CTS1
DTR1
DCD1
RING1
TXD
RXD
RTS
CTS
DTR
DCD
RING
Serial Port
Serial Port
L610
Client (DTE)
GND GND
Figure 3-13 UART Full mode
The L710HG UART is 1.8V interface. A level shifter should be used if user’s application is equipped
with a 3.3V UART interface. The level shifter TXB0108RGYR provided by Texas Instruments is
recommended. The reference design of the TXB0108RGYR is in the following figures. About the
application as below:
Figures 3-14 Voltage transfer Reference Circuit