User's Manual

ADM Technical Description RFID-LSCAN
File: ADM UserMan.doc Page 12 of 12
Status: Rev1 Last Update: 9/21/2010 3:49:00 PM
3.7.2 Backup battery
The main unit is equipped with a backup battery that allows the unit to continue operate for a
limited time without the battery pack. The backup cell is only used when the battery pack is
depleted or not connected.
Table 4 – Backup Battery Characteristics
Value Parameter Conditions
Min Typ. Max
Power saving mode,
excitation every 5min, one
SMS/day, max. LF field
3 days
Battery Life (per charge)
Continuous mode, one
SMS/day, min. field strength
16 hours
Recharge Cycles 300
Charge Temperature 0
o
C +45
o
C
Storage 1 year -20
o
C +45
o
C
4. ENVIRONMENTAL
Operating temperature range: -20
o
C - +60
o
C (except USB flash drive)
Storage temperature range: -20
o
C - +45
o
C (1 year)
Drop test: 1m drop on concrete surface, no structural and functional damage
5. REGULATORY
FCC compliance notice
Caution:
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
IC compliance
This Class B digital apparatus complies with Canadian ICES-003.
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.