Manual

9
2. Key in the name of the cartridge using the keypad and press
the ENTER button. The LCD will display the cartridge
and the scroll through the load information. If more than
one cartridge is stored in memory using the same cartridge
name, the first one stored will be displayed.
3. To dispense this load, press the ENTER button again.
WARNING: Be sure that the correct powder is in the
reservoir.
4. Follow steps discussed in F (3) to select other cartridges.
5. Press the CAL/ZERO button to exit from memory and
return to the standard Scale and Dispense mode.
H. Recall Memory Using a Memory Location Number
The 1200 DPS will store 20 loads in memory. Each load is
automatically assigned a number from 1 to 20. It may be faster
to locate a load by using its memory location number.
1. Press the RECALL button and the LCD will display “C=_
_ _ _”.
2. Press the ٠/MEM# button (on the keypad) and the LCD
will display “MEM=01” the first memory position.
3. Key in the memory location number and press the ENTER
button. The LCD will display the cartridge stored at that
memory number and scroll through the load information.
4. If the selected load is not correct, press the ٠/MEM#
button again (after step 3) to choose a new memory
location number.
5. Press the ENTER button to dispense this load.
WARNING: Be sure that the correct powder is in the
reservoir.
I. Edit Memory
1. Follow steps discussed in F,G, or H to select a load in
memory that you want to edit.
2. Press the EDIT MEM button to edit the cartridge name,
powder or weight.