Manual
11
kind of powder was used last. This is extremely
dangerous. To begin cleaning the dispenser, lower the
powder cleaning chute on the rear panel behind the powder
reservoir. Be certain that you have a container under the
chute to catch all the powder from the reservoir and powder
box. Lift the powder shut-off door to allow the powder to
flow out. The cleaning brush can be used to remove any
remaining powder. When empty, remove the reservoir tube
and reservoir base by sliding the latch on top of the
Dispenser to the left. Then lift the reservoir base up and
out. Place the rubber cap on the end of powder tube to
prevent powder spillage. Powder feed tube can be easily
removed by inserting J shaped rod in small hole in the
motor coupling as shown in Figure A. Then unscrew
powder-dispensing tube by turning in counter clockwise
direction. Be careful to catch any remaining powder that
may still be in the tube. Now with the powder chute
closed, press in the powder box from the back and release
it. The box will pop out slightly for easy removal and
cleaning. To reassemble the dispenser, push the powder
box back in until it clicks in, slide the powder tube back
through the bushings in the powder box and screw it to the
motor shaft until finger tight. Place looped end of J shaped
rod under motor coupling to assist in aligning the powder
feed tube to the coupling threads. See Figure B. Snap the
reservoir base back inside the powder box and lock in with
the sliding latch. Reinstall the reservoir tube.
Figure A Figure B