User's Manual

Installation
Install Mounting Brackets
Caution:
This device is intended to transmit RF energy. For protection against RF exposure to humans
and in accordance with FCC rules and Industry Canada rules, this transmitter should be
installed such that a minimum separation distance of at least 20 cm (7.8 in.) is maintained
between the antenna and the general population. This device is not to be co-located with
other transmitters.
Equipment Needed: Phillips No. 1 screwdriver and a Torque wrench capable of measuring to
50 inch pounds (5.64±.56 N/m).
Note: Torquing tool is not supplied by LXE. Bolts, washers, and wrench needed when
attaching the bottom mounting bracket to the vehicle are not supplied by LXE.
Several types of mounting systems are provided for the VX6:
RAM mount system:
Available RAM ball base or RAM clamp mount
U-Bracket system:
Provision for integrated UPS battery mount
Available without U-Bracket for vehicles previously equipped with an LXE vehicle
mounted computer
Remote mount for UPS battery pack
Before installation begins, verify you have the applicable vehicle mounting bracket assembly
components necessary for your mount type, as shown in the following figures.