Quick Start Guide

Table Of Contents

6 7 8 9 10

11 12

6 7 8 9 10

11 12

Andromeda ETCSxA.pdf 1 27/4/21 12:40

ETCS1A

PROTOTYPE Artwork Specifications

Pad Print on this side

of device

Safety and compliance

This device operates on licensed RF spectrum. Check

that it is approved for operation in your country before

operating it. Ensure installation complies with all relevant

local regulations and requirements.

Troubleshooting

Further installation, activation and troubleshooting

information is available at incyt.io/support

Andromeda

Quick Start Guide

Product Overview

Satellite Antenna

LED

Device ID

Rubber Pads

Ø 5mm diameter mounting holes

For help visit incyt by LX

incyt.io/support

Apple and the Apple Logo are trademarks of Apple Inc., registered in

the U.S. and other countries. App Store is a service mark of Apple Inc.,

registered in the U.S. and other countries.

Google Play and the Google Play logo are trademarks of Google Inc.

3 44

PAGE 1
F Product Overview E 5 5 D ETCS1A PROTOTYPE Artwork Specifications C Pad Print on this side of device 2 B 1 A Safety and compliance 27/4/21 12:40 5 Ø 5mm diameter mounting holes 1 6 5 Satellite Antenna LED Device ID Rubber Pads 4 Andromeda ETCSxA.pdf 4 7 8 9 10 Google Play and the Google Play logo are trademarks of Google Inc. 1 2 3 4 3 Apple and the Apple Logo are trademarks of Apple Inc., registered in the U.S. and other countries. App Store is a service mark of Apple Inc.
PAGE 2
Getting Started 1 Download the Incyt by LX app on the iOS AppStore, or Google Play store on your mobile device. 2 Create a new account or login with your 5 The device is delivered in a dormant state. Activate before use by following the steps below. Ensure the device is placed: outside with an unobstructed view of the sky, and within cellular network coverage Within network coverage existing account. 3 Follow instructions in the app to pair your device.
PAGE 3
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.