Operation Manual

V7 Version 3.01 October 2013
Page 3 of 48
5.3.4.15 Temperature Offset 21
5.3.4.16 Inertial assisted vario 21
5.3.5 Sounds 21
5.3.5.1 Sounds settings 22
5.3.5.2 Equalization 24
5.3.6 Units 25
5.3.7 Display 26
5.3.8 Communication 27
5.3.8.1 Bluetooth on PDA port 27
5.3.9 Polar and Glider 29
5.3.10 Flarm 30
5.3.11 Password 30
5.3.12 Reset of accelerometer (g-meter) 31
5.3.13 About 31
6 Variometer and Altimeter 32
Altimeter 32
6.1 Speed Command 32
7 Flying with the LXNAV V7 33
7.1 On the Ground 33
7.1.1 Power on Procedure 33
7.1.2 Set Elevation and QNH 33
7.1.3 Pre-flight Check 34
7.2 Airborne 34
7.2.1 Final glide calculation 34
8 Installation 35
8.1 Installing the LXNAV V7 36
8.2 Connecting LXNAV V7 36
8.3 Cutout of V7 36
8.4 Installation of options 37
8.4.1 Ports and Wiring 37
8.4.1.1 LXNAV V7 ports 37
8.4.1.2 LXNAV V7 wiring 39
8.4.2 Configurations 40
8.4.2.1 NANO – V7 – OUDIE 40
8.4.2.2 NANO – V7 – MINIMAP 40
8.4.2.3 COLIBRI2 – V7 – OUDIE 40
8.4.2.4 COLIBRI,VOLKSLOGGER– V7 – OUDIE 41
8.4.2.5 Flarm/RedBox– V7 – OUDIE 41
8.4.2.6 FlarmMouse - FlarmView -V7 - OUDIE 41
8.4.2.7 FlarmMouse – V7 – OUDIE 42
8.4.3 V7D option (V7 repeater) 42
9 Firmware Update 43
9.1 Updating LXNAV V7 firmware using OUDIE 43
9.2 Updating LXNAV V7 firmware using PC 44
10 Options 46
10.1 Rear Seat Device (LXNAV V7D) 46
10.1.1 Data Exchange 46
10.1.2 Cable Wiring (LXNAV V7D) 46
10.2 Available cables for GPS and PDA ports 46
11 Revision History 48