Operation Manual

V7 Version 3.01 October 2013
Page 27 of 48
o OFF bar is not displayed
o MinMax shows minimum and maximum vario value in last avereger time (by
default 20s)
o G-meter shows minimum and maximum G-force in last flight
5.3.8 Communication
Use to configure baudrate for GPS and PDA port.
Each port can be configured separately. If your PDA device does not support automatic
switch to DIRECT LINK between GPS and PDA port, here is manual GPS-PDA link menu.
When autobaudrate is enabled, LXNAV V7 will automatically search on all speeds to receive
valid data. When receives a valid NMEA sentence it will lock on that baudrate and stop
searching. In case that communication is lost LXNAV V7 will start again searching on all
baudrates.
Baudrate on PDA must not be lower than the setting on GPS port
To get better performance of LXNAV V7 it is recommended that both baudrates
be set as high as possible.
NMEA output on PDA port can be enabled or disabled. If you are not using a PDA port,
this setting should be disabled.
5.3.8.1 Bluetooth on PDA port
From version 2.02, V7 supports plug and play LXNAV V7 BT module. Module can be plugged
in PDA port.