Operation Manual

NANO
3
Version 1.0 April 2014
Page 20 of 33
5.3 Setup Menu
5.3.1 Flight recorder
Under this page; flight recorder, pilot information and glider data are configured.
• Recording interval sets the interval when the GPS position will be stored in flight
• Auto Finish will allow the automatic finish of the flight, under certain conditions.
Uncheck this item for wave flying. (ground speed is used to indicate the end of a
flight and in wave it is possible to be stationary or even fly backwards in relation to
the ground)
• Auto Off will power off the NANO
3
30 minutes after the flight is finished
• Logger always on will force the logging/write position to an IGC file immediately
after power on. Normally the NANO
3
logger is triggered by ground speed exceeded
40km/h or vario over 1m/s. This function is recommended to be enabled only for
hang gliders.
• Pilot name must be entered here
• Co-Pilot name must be entered here, if glider is doubleseater.
• Competition sign of glider
• Registration of glider
• Glider type
• Glider class
5.3.2 Display
Under this menu the following items can be set:
• Brightness at USB power will set the level of backlight, when USB power is
present
• Brightness on battery will set the level of backlight, when USB power is not
present
• Screen fade enables fading screen to level “Fade brightness” after “Fade
Timeout” time
• Screen off enables power off of the screen after “Off timeout” seconds.
• Wake screen on events enables turning on the screen, even if the screen is off