Operation Manual

NANO Version 2.0 May 2012
Page 19 of 27
5.1.1.1 Pilot information
Enter pilot and glider information in the pilot section. In the top right you will find two icons.
The first icon will show a list of stored pilot information and second will add current pilot
information to the list.
5.1.1.2 Task declaration
Before creating a task you have to load the waypoints from which the task will be created.
Press the Load Waypoints button to load waypoints. Waypoints can be loaded from a CUP
formatted file. Once waypoints are loaded you can create a task by typing the names of the
waypoints. Use the icons in the upper left corner of the task declaration group to add or
delete a point or to clear the whole task. Task points can also be deleted by pressing the
DEL key or can be inserted by pressing the INS key.
5.1.2 Using Bluetooth or serial interface
Flight declarations can also be uploaded using the serial interface or Bluetooth (See chapter
0 for Bluetooth pairing). The NANO must be running in normal operating mode.
The protocol used for uploading the declaration is same as used for Colibri, LX20, Posigraph
or any other LX loggers.
When connecting through the serial interface you should use the same baud rate
as is set for NMEA output on the NANO.
When connected through Bluetooth baud rates are not important.
Please refer to the manual for the software used to upload flight declarations. (E.g. Seeyou
Mobile, pocket*Strepla, Winpilot, FlyWithCE)