Operation Manual

LX90xx system Version 4.0 February 2014
Page 134 of 151
8.2.6 Task Finish
When reaching final glide, a message task on final glide will be displayed. The main display
unit will also warn you, when you are two minutes to finish. On entering the finish zone the
task stops automatically and a message will be displayed.
If you want to fly a new task without landing, load the new task and press the RESTART
button.
The Navigate to nearest point option is very useful and actually a must if a
finish cylinder is used with significantly large radius. Enabling this option will
calculate the final glide to the edge of the cylinder rather than to the centre of
the cylinder.
8.3 Procedure after Landing
IGC Regulations require a straight line (base line) in the barogram at the beginning and end
of the flight. For this reason that it is essential not to switch the unit OFF immediately
after landing, but to wait a few minutes. First the message “Flight will finish in 10 seconds”
will appear and then the message “Calculating security!”
The flight is finished when the message Calculating security disappears. At that moment the
statistics page will be changed back to logbook view. Now it is safe to switch off the
instrument.