Operation Manual

LX90xx system Version 4.0 February 2014

Page 111 of 151

 STARTS will open new dialogue, where user can enter multiple start points.

 Press LOAD to load the task from the active waypoint file.

 Press SAVE button to store the task to the active waypoint file. This task can later be

loaded from the active waypoint file.

 TO NANO button will be available, if Nano flight recorder is connected to the main

display unit. Press this button to send declaration to it.

 INVERT action will invert the complete task.

 INS PNT will insert a new point above the current cursor position.

 DEL PNT will delete a point at the current position.

 CLEAR will completely erase the task.

 MOVE UP is used to move selected point upwards within the task.

 MOVE DN is used to move selected point downwards within task.

6.7.2 Task Creation

Make sure that at least one waypoint file is loaded into the main display unit and that it is

checked and marked as an active waypoint file. Refer to Chapter 6.1.5.1 for details on how

to upload waypoint files to the system.

Select task time and press the EDIT button. Enter the task time if required. Rotate the

PAGE selector knob to increase time in 15 minute steps and the ZOOM selector knob to

increase task time in 1 minute steps. Close the task time edit and rotate the PAGE selector

knob to select the first empty point.

Press the EDIT button and enter a turn point name. Entering a point name is very straight-

forward. Enter the first letter of the task point name using the PAGE selector knob. The

“Helper” will show the first waypoint that matches this letter.

Press the CHAR>> button and the cursor will move to the second letter. Use the PAGE

selector knob to select the second letter. If you want to return to the first letter turn the

ZOOM selector knob anticlockwise.

Repeat this procedure until your desired point is selected. Press the SELECT button to

complete this selection. If you do not know exact name of a point just select the first letter

and press the SELECT button. Now scroll to the desired point using the PAGE selector

knob. Press the SELECT button once more to complete this selection.

The task edit dialogue should now look like the screen below. The letter “S” indicates you

entered the start point.

Move the cursor down to the next empty point and repeat the above procedure until the

entire task is entered.