Operation Manual

LX90xx system Version 4.0 February 2014
Page 143 of 151
Data is divided into two groups; flight parameters and navigational data. If a specific value
is checked this value will be automatically be received from the other device.
Check MacCready, Ballast and/or Bugs to receive the current MacCready value, current
ballast setting or bugs from the other device.
If Waypoint is checked a new waypoint target will be automatically assigned when the user
changes the waypoint target on the other device. A message “Waypoint target received”
will be shown on the screen and you will be navigating to the same waypoint as other
device. Please note that it is not necessary to have this waypoint in your databases as the
complete waypoint information is sent. If Waypoint is not checked it is still possible to
send a target to other device using the SEND action in waypoint mode. The same applies
to the Airport checkbox. The message “Airport target received” is displayed. If the Task
checkbox is checked the task will be synchronised with the other device.
When flying an assigned area task it is worth having Task unchecked. This will
allow one pilot to play with “what if” scenarios. Once a proper direction is found
you can send the task to the other device using the SEND action in task mode.
11.2.2 Cable Wiring
1 2 3 4 5 6 7 8
A
B
C
D
87654321
D
C
B
A
1
6
7
4
9
5
SUBD15 Connector / female
LX7000 DIGITAL UNIT
+12V DC IN
white
red
shield
black
yellow
GND
+12V
B
A
RS485
SUBD9 / female
1
9
2
10
3
11
4
12
5
13
6
14
7
15
8
B
A
30 cm
1
6
7
4
9
5
RS485
SUBD9 / male
1
6
7
4
9
5
SUBD9 / male
350 cm
RS485
485 CABLE
white
red
shield
black
yellow
B
A
white
red
shield
black
yellowA
B
WIRING LX8000 D