Operation Manual
LX90xx system Version 4.0 February 2014
Page 132 of 151
8.2.3 Over Turn Point
When a turn point observation zone is reached the message
“Inside zone”
will be displayed
and the task will auto advance to the next turn point if the Auto next option was selected
(see Chapter 6.7.4).
When the Auto next option was not selected the message NEXT will be displayed. Press
the associated button to advance to the next turn point. If for some reason you missed this
message you can always advance the task to the next turn point by pressing the NEXT
button. Go to task mode. In the upper row the NEXT button is shown. Press this button
and navigation will be advanced to next turn point.
In case you did not reach turn point and you wish to continue navigation towards the next
point anyway press the NEXT button.
A message will appear. If you confirm this with YES the task will be advanced to the next
turn point and it will recalculate the task taking the optimal fix as the task point.
8.2.4 Entering Assigned Area
Most probably when entering an assigned area auto advance is going to be turned off. The
message
“Inside zone”
will be shown and buttons CLOSE and NEXT will appear in the
lower row. Pressing the CLOSE button will dismiss the inside zone message. The task will
be auto advanced to the next point when leaving the assigned area. If you want to auto
advance to the next turn point earlier you may always press the NEXT button in task mode
(see 8.2.3).