Operation Manual

Do not forget to set the speed command input setting to TASTER (see Chapter
5.1.12.1).
The original stick grip should be removed and replaced with the new one. On the top of the
new grip there are 9 push buttons. An additional button positioned on the front side is for
climb/cruise change over. Both the PTT and climb/cruise buttons are wired separately. All
remaining buttons are connected to the built-in microcontroller and only four wires should be
connected to the RS485 system bus. A very small interface printed circuit board connects
four wires coming out of the stick to the 485 System bus.
After installation there is no special setting required on LX 8000 side as the remote
stick will be automatically detected.
Use the left/right arrow to zoom in and out. Use the up and down arrow keys to toggle
between pages within the current mode. Press the upper-right button to enter the next
mode. Press the upper-left button to move to the previous mode.