Operation Manual

Port on LX8000 Cable Port on TRX 1090
LX8000 FLARM -> via cable (Flarm-TRX1090) -> TRX Port4 (Flarm original or
compatible)
LX8000PC (5pin
rounded
connector)
<- via cable (TRX LX9000) <- TRX Port2(Flarm Compatible
display, set to 19200)
Using the TRX-Tool program you should configure also TRX-1090 to be used together with
the LX8000. Run the TRX-Tool program and connect the TRX-1090 to PC using a USB cable.
Select Port4 tab and change connected equipment to LX8000 (or FLARM without RX line
connected).